1. Do you have an old account but can't access it?


    See Accessing your GIRS Account or Contact Us - We are here to help!
    Dismiss Notice

RODI reading 87ppm

Discussion in 'General Discussion' started by Armydog, May 16, 2015.

  1. Armydog

    Armydog Expert Reefkeeper

    Ok so i have replaced all of my filters and di resin and added another stage to my system. The only thing i didnt replace is the gpd Membrane. Why is it reading this high :/ has anyone had this problem? Should i replace the membrane also?
     
    Armydog, May 16, 2015
    #1
  2. F.D. Reefer

    F.D. Reefer Well-Known ReefKeeper

    Could b air in Gpd housing.
    Iv had to kinda tilt it bak & forth & up & down to get all air outa mine b4. & then it worked fine.
    I wouldn't think you'd need to change membrane, but I'm no expert.
     
    F.D. Reefer, May 16, 2015
    #2
  3. blackx-runner

    blackx-runner Administrator Website Team Leadership Team

    What is it before and after the RO membrane? That will be the best indicator for needing to replace the membrane. A good 75gpd membrane will have a rejection rate of 98%. I think typical for membranes we buy for our units is 95-98%. If you aren't getting that it's time to replace it.
    They now have 3 position inline TDS meters that would come in handy. Before and after the RO membrane, then after the DI would be the best places to test TDS. A simple press of the button and you can gauge filter life.
    I wouldn't run anything more through your DI until you get figured out. If you're outputting 87ppm after the DI you might have even exhausted it already.
     
    blackx-runner, May 16, 2015
    #3
  4. Nik

    Nik Experienced Reefkeeper

    Are you sure your meter is good?
     
    Nik, May 17, 2015
    #4

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice